If you're replacing your old refrigerator, this DIY project covers everything you need to know to install the plumbing. Wrap the remaining male threads on the quick-tee adapter with thread-seal tape.
Leave the excess water line behind the refrigerator. We'll remove comments that violate our policy.
Required Tools for this Project
Run the new supply tube to the back of the refrigerator. Tighten all three nuts on the quick-tee adapter with pliers or an adjustable wrench.
If there is no water dispenser, throw away the first full batch or two of ice to make sure it is all clean and ready to use. Then decide which one of three refrigerator water line connection options you will use: Reader's Digest Taste of Home Recipes. Also, fridge hookup for leaks where the supply tube connects to the refrigerator before fridge hookup the appliance back into place.
Plumb the fridge
Installing a Water Line Is a Snap. Shut off the water at the valve that controls the cold-water supply pipe to the faucet.
You may have three water supply lines beneath the sink; two lines connect directly to the faucet while the third line connects to the dishwasher. If there are no branch shutoff valves, you can turn off the water by closing the main water supply valve to the entire house.
To begin, shut off the water at the main valve, then open the sink faucet and another lower level faucet to drain the pipe. They come in various sizes to suit the job. There is a hidden trick here, though: The fridge hookup of the required gap varies with different models and types of refrigerators, so make sure you check this and have the space you need.
Never put a refrigerator on its side or upside down: Coil the excess water line behind the refrigerator. Attach the free end of the copper tubing to the valve.
Share your voice
Be prepared for a small amount of You will also need a longer flex water supply tube to run from the water pipe to the refrigerator. Alternative secunderabad dating These photos show alternative ways to connect to the cold water pipe. Now the refrigerator is connected.
Cut out a small section of the cold water pipe and solder in a copper tee. It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce the outer wall of the pipe when screwed inward.
So you've just taken delivery of a new refrigerator. Avoid sharp turns that can bend the tubing. Push the refrigerator in slowly, checking that it is not getting caught on any cables or flooring.
However, leave the plastic covering on the refrigerator doors in place: A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it.
To straighten coiled tubing not the entire rollhave a partner hold the end of the tube flat on the floor, then push the roll against the floor while unrolling to the length you need to go through the cabinets.
- Gmail hookup
- Dating fails page 3
- Flowers for early dating
- Dating door test
- Dating site for chemists
- What does dating mean on pof
- Dating portal leipzig
- Zeus dating site
- Dating sites punjab
- How to know if boyfriend is on dating sites
- Top phone dating sites
- Mums dating site
- Best dating sites for serious daters
- Free date hook up messages
- Subject line for online dating message
- Is eharmony a good dating website